Technical Data; Noise/Vibration Information - Bosch AQT 33-11 Originalbetriebsanleitung

OBJ_BUCH-2334-002.book Page 14 Wednesday, February 18, 2015 3:43 PM
14 | English
Symbol Meaning
Lo Low pressure
Hi High pressure
Accessories
Intended Use
The product is intended for cleaning areas and objects out-
side the house, tools, vehicles and boats, if the appropriate
accessories such as cleaning agents approved by Bosch are
used.
Intended use is related to operation within 0°C and 40°C am-
bient temperature.
This product should not be used for professional use.

Technical Data

Pressure washer
Article number
Rated power
Supply temperature max.
Supply rate min.
Allowable pressure
Rated pressure
Rated Flow
Maximum inlet pressure
Autostop function
Weight according to
EPTA-Procedure 01/2003
Protection class
Serial number
Starting cycles generate brief voltage drops. Interference with other
equipment/machines may occur in case of unfavourable mains system
conditions. Malfunctions are not to be expected for system impedances
below 0.153 ohm.

Noise/Vibration Information

Sound emission values determined according to
EN 60335-2-79.
Typically the A-weighted noise levels of the product are:
Sound pressure level 85 dB(A); sound power level 94 dB(A).
Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60335-2-79:
2 2
a =4 m/s , K=1,5 m/s .
h
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2011/65/EU, until 19 April
2016: 2004/108/EC, from 20 April 2016 on: 2014/30/EU,
F 016 L81 121 | (18.2.15)
2006/42/EC, 2000/14/EC including their amendments and
complies with the following standards: EN 60335-1,
EN 60335-2-79.
2000/14/EC: Guaranteed sound power level 98 dB(A). Con-
formity assessment procedure according to Annex V.
Equipment category: 27
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-HG/ENS-PA2,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
17.02.2015
AQT 33-11
Mounting and Operation
3 600HA7 6..
kW 1.3
Action
°C 40
Delivery Scope
l/min 5.5
Mounting cable bracket/in use storage for
bar 11
gun
MPa 7.4
Connecting/disconnecting high pressure
l/min 4.7
gun to lance
MPa 1
Connecting/disconnecting nozzle

Connecting/disconnecting high pressure
water supply hose/nozzle
kg 4.5
Connecting to the water supply
/II
Switching On and Off
See serial number (rating
Adjust water jet
plate) on pressure washer.
Connect detergent bottle
Clean nozzle
Clean the water filter
Transport
Storage
Selecting Accessories
Starting
For Your Safety
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Only use approved exten-
sion cables. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
- 1.5 mm
- 2.5 mm
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
2
– max length 20 m
2
– max length 50 m
Figure Page
1 244
2 244
3 245
3 245
4 246
5 246
6 247
7 247
8 248
9 248
10 249
11 249
11 250
12 251
Bosch Power Tools