For The Installer; Transport; Side Panels - Nibe Compact Sol Benutzer- Und Installateurhandbuch

For the Installer

GENERAL
The pressure vessel is designed and manufactured for
a maximum cut-off pressure of 10 bar.
The water heater is insulated with EPS (environmentally
friendly cellular plastic), which provides good thermal
insulation.
The outer casing consists of powder-coated steel plate
and the rear section is in galvanised steel plate.
The flanged, stainless steel immersion heater, in a Ø 80
mm connection opening, allows for simple dismantling,
internal inspection and cleaning of the pressure vessel.
A complete set of factory-fitted valves, consisting of a
mixing valve, non-return valve, vacuum valve,
safety/draining valve and shut-off valve.

TRANSPORT

Compact Sol should be transported and stored vertically
in a dry place. However, the Compact Sol may be care-
fully laid on its back when being moved into a building.
NIBE Compact Sol | GB
15 - 40 mm
30 - 50 mm
0 R
ASSEMBLY
The water heater is only designed for upright installation.
Position Compact Sol on a firm base that can take the
weight, preferably on a concrete floor or foundation.
Use the water heater's adjustable feet to achieve a ho-
rizontal and stable set-up.
20-55 mm
30 - 50 mm
The area where the Compact Sol is located must be
frost-proof and equipped with a floor drain.
REMOVING THE COVERS
FRONT COVER
Pull the hatch straight out.

SIDE PANELS

The lower section of the side panels can be removed
during installation, which facilitates access from the
sides. The side plates can even be reinstalled in confined
spaces.
17