SUNTEC KLIMATRONIC Motion plus Bedienungsanleitung Seite 16

1. After starting the unit you can hear a start signal, the unit will be automatically set in a standby mode.
2. Power button: Once you press this button, the model switches to cooling mode (temperature 25° C). By
default, the lowest fan speed is set. Press the Power button again, the unit will switch off and you will hear the
final signal.
3. Cooling mode
Press the MODE button until "Cool" appears on the display.
-
Press TEMP + or TEMP - to adjust the temperature (16° C-31° C).
-
- Press the SPEED button to adjust the fan speed.
4. Dehumidifying mode
- Press the MODE button until the indicator light shows "DEHUM".
The fan speed is automatically set to "low".
-
5. Fan
- Press the MODE button until the indicator light shows "FAN".
- Press the SPEED button to adjust the fan speed.
6. Timer
Timer On:
- Turn off the unit. Press the TIMER button and set the desired waiting time for automatic system start
(use buttons "Temp -" and "Temp +").
- The adjusted time appears on the display.
Press the TIMER button to save the settings
-
The unit will automatically turn on by the adjusted time.
-
You can reset the settings anytime. Press the TIMER button to deactivate the timer.
-
Timer Off:
- You can set the timer to turn off the unit by the fixed time.
- Turn on the unit. Press the TIMER button and set the time, by which the unit has to turn off (use
buttons "Temp -" and "Temp +").
Press the TIMER button to save the runtime. The indicator light for "timer" indicator lights.
-
Remote control
1. POWER: Power on or off.
2. MODE: Press the
dehumidifying or fan mode.
3. TEMP+: Press the button to increase the temperature.
4. TEMP-: Press the
temperature.
5. TIMER: Press the button to turn on or off the timer.
6. SPEED: Press the button to adjust the fan speed.
Internal Water Tank Full Alarm Function
The inner water tank of the local air conditioner has a water level safety switch, which controls the water level. If
the water tank is full, the water level indicator lights on the control panel. To empty the water tank remove a
rubber stopper on the bottom and let the water leak in a container.
Cleaning, Fig. 6
1) Before starting cleaning or maintenance, turn the power off by
pressing the POWER button, wait a few minutes and then unplug the
power cord from the outlet.
2) Do not clean the local air conditioner with water.
3) If the unit is damaged, please contact your dealer immediately.
. The indicator light "Timer" is on.
button to select cooling,
button to decrease the
16