Installing The Cap Over The Universal Connector; Installing The (Optional) Speaker/ Microphone Or Headset - Kenwood NX-3000 Serie Benutzerhandbuch

INSTALLING THE CAP OVER THE UNIVERSAL
CONNECTOR <NX-3200/ NX-3300>
1 If you are not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector.
2 Secure the cap in place using the
dressing screw.
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE
OR HEADSET <NX-3200/ NX-3300>
1 Insert the guide of the speaker/ microphone or headset
connector into the groove of the universal connector.
2 Secure the connector in place using the attached screw.
Note:
When not using an optional speaker/ microphone or headset, install
●
the cap over the universal connector.
The noise canceling function on KMC-54WD Speaker Microphone
●
works using the built-in DSP of the transceiver, and can be used only
with the NX-3000 series Portable models.
Optional speaker/
microphone
Universal
connector cap
15