Installing/ Removing Alkaline Batteries (Optional Battery Case) - Kenwood NX-3000 Serie Benutzerhandbuch

INSTALLING/ REMOVING ALKALINE BATTERIES
(OPTIONAL BATTERY CASE)
WARNING
Do not install batteries in a hazardous environment where sparks
●
could cause an explosion.
Never discard batteries in fire; extremely high temperatures can
●
cause batteries to explode.
Do not short circuit the battery case terminals.
●
Do not use rechargeable batteries.
●
Note:
If you do not plan to use the transceiver for a long period, remove the
●
batteries from the battery case.
This battery case has been designed for transmitting at a power of
●
approximately 1 W (the low power setting on your transceiver). If you
want to transmit a stronger signal (using the high power setting on
your transceiver), use an optional rechargeable battery pack.
.
1 To open the battery case, press
on the two tabs on the upper rear
of the case, then pull the two
halves apart.
2 Insert 6 AA (LR6) Alkaline batteries
into the battery case.
Be sure to match the polarities with
●
those marked in the bottom of the
battery case.
3 Align the tabs of the cover with
the base, then push down on the
cover until it locks in place.
13