Herunterladen Inhalt Inhalt Diese Seite drucken

Setting And Starting A Programme - Electrolux GA60IEEVWE Benutzerinformation

Vorschau ausblenden Andere Handbücher für GA60IEEVWE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9.1 Using the detergent
A
B
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press
again and again until the
indicator of the programme you want
to select comes on.
• If you want to select the
MyFavourite programme, press
MyFavourite.
The programme indicator of the selected
programme flashes.
The display shows the programme
duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme indicator stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with delay
start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The indicator of the selected programme
continues to flash.
3. Close the appliance door to start the
countdown.
The programme indicator stops flashing
and comes on with fixed light.
• When the countdown is completed, the
programme starts.
• While the countdown is running only
the buttons Reset and Delay are active.
It is not possible to change the
programme or options.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme will end.
ENGLISH
13

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ga60ieevcn

Inhaltsverzeichnis