Electronic Adjustment - Electrolux GA55LI220 Benutzerinformation

64 www.electrolux.com

Electronic adjustment

1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold buttons (8) and (9) at
the same time until the programme indi-
cators above buttons (8), (9) and (10)
flash.
3. Press button (10).
FILLING THE SALT CONTAINER
FILLING THE RINSE AID DISPENSER
B
A
A
-
+
C
D
• The programme indicators above
buttons (8) and (9) go off.
• The programme indicator above but-
ton (10) continues to flash.
• The display shows the setting of the
water softener. Example:
5.
4. Press button (10) again and again to
change the setting.
5. Deactivate the appliance to confirm.
1. Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it, af-
ter you fill the salt container, start a
programme.
1. Press the release button (D) to open
the lid (C).
2.
Fill the rinse aid dispenser (A), no more
than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the re-
leased quantity (B) between posi-
tion 1 (lowest quantity) and position
4 (highest quantity).
= level