Commissioning And Adjustment Of The Torque - Powerfix PDS 45 A1 Bedienungsanleitung

Commissioning and adjustment of the
torque
1. Loosen the locking screw
of the torque wrench by turning it anti-clockwise.
2. The precise setting of the torque value is made by using the ring
GB
scale
process is explained for a torque of 120 Nm.
3. Turn the hand-grip until its upper edge reaches the kinked down-
wards marking of 112 Nm and the "0" of the ring scale
the centre line of the main scale
you have made the rough adjustment.
4. Turn the hand-grip
scale
With this you have made the fi ne adjustment and the torque wrench
is now set to 120 Nm.
5. Turn the locking screw
6. Use the switching lever
(tighten or loosen) of the ratchet.
7. To attach and detach the extension piece/socket wrenches, press
the release button
26
and the main scale
further to the right, until the "8" on the ring
meets the centre line of the main scale
on the top of the torque wrench.
(do not remove it) at the lower end
. In the following example, this
(see Figure A). With this step,
clockwise to lock the set torque value.
to change the direction of rotation
meets
(see Figure B).
PDS 45 A1