vita MultiPump Bedienungsanleitung Seite 4

VITA MultiPump
EN In order to put the VITA MultiPump into operation, a VITA vacuum pump
(prod. no. DVPU220, DVPU110 or DVPU100) must be available.
The VITA MultiPump is delivered with two USB cables as well as vacuum tube
material for connecting two furnaces. In order to operate up to four furnaces, the
accessory set (Prod. No. D61004) is required.
The VITA MultiPump can only be operated using a VITA vPad excellence with a
serial number higher than 2320152050 as well as all models in the VITA VACUMAT
6000 M and VITA VACUMAT 6000 MP series, in combination with a VITA vacuum
pump.
Please note that in order to be able to operate the VITA MultiPump, software
update 150707 or a later version must be installed on all VITA vPads and dental
furnaces from the series listed above.
Please also note that it is possible to operate the VITA MultiPump with just one or
up to four VITA vPad excellence devices. The following diagram provides an
example of how four dental furnaces from the above series can be operated with
one VITA vacuum pump, one VITA vPad excellence and one VITA MultiPump.
Note:
Before connecting the tubes and cable, please remove the corresponding
stoppers in each case from the VITA MultiPump. Please leave the stoppers
in the connections that you do not currently wish to use in order to prevent
these connections from becoming contaminated.
4
– Information · Información · Informazioni
Information