Alarm; Snooze; Weather Forecast; Barometer - Auriol 4-LD4437 Bedienungs- Und Sicherheitshinweise

Alarm

The weather station has 2 alarms, which can be set separately. Press the MODE-button 15 to select alarm 1 or alarm 2.
The corresponding alarm symbols will appear. When displaying alarm 1 or alarm 2, press and hold the MODE-button
15, to enter setting mode. The hours will blink on the display. Set the hours by pressing the -/ -button 11 or the
+/12/24 -button 14 and confirm your setting by pressing the MODE-Taste 15. Set the minutes in the same way. Press
the AL/ON/OFF button while displaying the alarm you wish to activate. Press the AL/ON/OFF-button 10, to activate
(on) or deactivate (oF) the alarm. If alarm 1 is activated the symbol
will appear. If no button is pressed within 5 seconds, the weather station will return to normal time display mode.

Snooze

Press the SNOOZE/LIGHT-button 12, to temporarily deactivate the alarm. The bell symbol will blink on the display.
After 5 minutes the alarm will sound again. Press any button except button 12 to shut off the alarm.

Weather forecast

The weather icons show a weather tendency for the next hours and not the current weather.
Should the forecast of your weather station be incorrect, you can adjust the display by pressing and holding the
HISTORY/WEATHER-button 27 for 3 seconds. The weather icon will blink. You can now select the correct weather icon
by pressing the °C/°F + -button 28 or the MAX/MIN- -button 29. Confirm your selection by pressing the
HISTORY/WEATHER-button 27.
Note: The weather station will start the forecast approximately 6 hours after the current weather was entered.
Sunny
Slightly cloudy
Cloudy

Barometer

Your weather station can show the air pressure tendency 25.
Air pressure rising
Air pressure constant
Air pressure falling
You can also select absolute or relative air pressure by pressing the Relative/Absolute-button 30. Rel. or Abs. will
appear on the display.
Note: The weather station measures the absolute air pressure. Your local weather service can supply you with the
relative air pressure for your location, which you can input into the weather station.
To change the relative air pressure, press and hold the Relative/Absolute-button 30 for 3 seconds. The air pressure
value will blink on the display and can be set by pressing the °C/°F + -button 28 or MAX/MIN-button 29. Confirm
your setting by pressing the Relative/Absolute-button 30.
Select the air pressure unit Hectopascal (hPa) or Inches of mercury (inHg) by pressing and holding the °C/°F + -button
28 for 3 seconds.

12-hour air pressure history

Press the HISTORY/WEATHER-button 27 to view the air pressure history for the last 12 hours.
0 – HR = current air pressure
- 1 HR = air pressure 1 hour ago
-2 HR = air pressure 2 hours ago... and so on

Outdoor sensor/channel setting

You can use the weather station with up to 3 outdoor sensors at the same time. Open the battery compartment of the
outdoor sensor and select a channel (1-3) by using the channel switch 39. Press and hold the CHANNEL-button 26 for
3 seconds or until an audible signal sounds. The weather station will now attempt to receive the signal 43. Now press the
TX-button 42 to manually transmit the temperature from the outdoor sensor to the weather station. Close the battery
compartment. Press the °C/°F-button 41 to select °C-Celsius or °F-Fahrenheit.
will appear. If alarm 2 is activate the symbol
Downpour
Rain
Snow
- 37 -