Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Take care that the drill bit is not out of line. Advance the tool according to bit
diameter and machine power. Observe the LED in the handle.
If it lights red, reduce your pressing force. In case the bit gets jammed, to
not dry to release it by switching the tool on and off. This would cause
premature wearing of the safety clutch. Switch the tool off immediately and
unfix the drill bit by turning to the left or right using an appropriate open-end
wrench. Cautiously pull the tool out of the borehole.
Fixing to Drill rig
Open the fixing by turning
the screw in direction of the
arrow until the guideway is
free.
Attention!
Before any work on the tool, disconnect the plug from the mains!
Fastening on the floor by means of vacuum
Don't use the vacuum mounting on the wall and overhead!
For a low-pressure mounting the surface where the base is mounted must be
not porous and must be flat and free of cracks.
If this is not the case, this kind of mounting can't be used. For the vacuum
mounting you need a vacuum pump, a vacuum hoses (see illustration) and
the vacuum set PLB 160. These items are available on request.
The PLD 160 is equipped with a special
accomodation for the diamond drill rig PLB 160.
For mounting the tool to the drill rig, the handle may
remain at its place.
Block the tool slide by means of the knurled
screw. Insert the tool into the drill rig. Fix the
tool by close the screw.
Rig Drilling
24
Werbung
