Checking The Battery Charging Level; Assembly - FLORABEST FALH 40-Li A1 Bedienungs- Und Sicherheitshinweise

Checking the battery charging
Q
level
Press the battery charging level button
o
check the charging level of the battery
pack . The charging level will be shown on
29
the battery level indication light
4 Green LEDs Battery pack fully charged
continuously lit
3 Green LEDs Battery pack 75% charged
continuously lit
2 Green LEDs Battery pack 50% charged
continuously lit
1 Green LED Battery pack 25% charged
continuously lit
1 Green LED Low battery charging level
flashing
Charge the battery pack
o
when it is at medium or low battery charging
level.

Assembly

Q
WARNING!
Always switch the product off and
remove the battery pack before
performing inspections, installing
accessories, making adjustments,
refilling fluids or lubricating!
WARNING!
The cutting edges of the saw chain are
sharp! Always wear protective gloves
when handling the saw chain!
to
30
.
32
29
before operation
Guide bar and saw chain
WARNING!
Always use a saw chain designed as "low-
u
kickback" or a saw chain which meets the
low-kickback requirements! A standard saw
chain (a chain which does not have the
kickback reducing guard links) should only
be used by an experienced professional
operator!
Nevertheless, a low-kickback saw chain
u
does not completely eliminated kickback! A
low-kickback or "safety" chain should never
be regarded as complete protection against
injury! Therefore always use a low-kickback
saw chain in conjunction with other kickback
protection devices!
Never attach a new saw chain to a worn
u
sprocket or place onto a damaged or worn
guide bar. The chain could spring back or
break, potentially leading to serious injury!
Assemble the guide bar
before operation. Use only a guide bar and
saw chain according to the technical data of the
product (see "Technical data").
1. Place the product on a suitable flat surface.
26
2. Loosen the bolts
remove them together with the cover
(see Fig. D).
3. Align the slot with the indexing latches
and place the guide bar
the pin for holding the guide bar
lower hole in the guide bar.
4. Place the saw chain
and over the guide bar
19
the cutters of the saw chain
away from the product along the top edge of
the guide bar . Fit the chain links into the
16
groove around the guide bar (see Fig. E).
and saw chain 17
16
anticlockwise and
25
22
onto them. Insert
16
24
into the
17
around the sprocket
16 . Make sure
are facing
17
GB / IE 35