Battery Pack - FLORABEST FALH 40-Li A1 Bedienungs- Und Sicherheitshinweise

Chain pitch:
Chain gauge:
Chain speed V :
0
Drive sprocket:
Oil tank volume:
Weight (excl. battery
pack, charger, cutting
accessories and harness): 3.0 kg
Weight (incl. battery
pack, charger, cutting
accessories and harness): 5.1 kg

Battery pack:

Type:
Rated voltage:
Capacity:
Number of cells:
Rapid battery
charger:
INPUT:
Rated voltage, frequency: 200 – 240 V ~ ,
Power consumption:
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Protection class:
Noise emission value
Noise measurement value determined in
accordance with EN 60745-1 and
EN ISO 11680-1. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level L
pA
Uncertainty K :
pA
Sound power level L :
WA
Uncertainty K :
WA
Guaranteed sound power
level L :
WA
28 GB / IE
9.5 mm (3/8 in)
1.3 mm (0.05 in)
4.5 m/s
6 teeth
approx. 15 cm³ (ml)
FAP 40 A1
Lithium ion
36 V
40 V max.
2.5 Ah (90 Wh)
10
FLG 40 A1
50/60 Hz
160 W
36 V
3.6 A
approx. 60 min
II /
: 80.2 dB(A)
3 dB
92.1 dB(A)
2.62 dB
96 dB(A)
(according to 2000/14/EC amended by
2005/88/EC)
Vibration emission value
Total vibration values (vector total of three
directions) determined in accordance with
EN 60745-1 and EN ISO 11680-1:
(rear handle)
Hand / arm vibration a
(gripping surface)
Hand / arm vibration a
Uncertainty K:
WARNING!
Wear ear protection!
WARNING!
The vibration level varies in accordance with
u
the use of the power tool and may be higher
than the value specified in these instructions in
some cases. There is a risk of underestimation
of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Measures
to reduce the vibration load are, e. g. wearing
gloves and limiting the working time. Wherein
all states of operation must be included (e. g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
NOTE
The vibration level specified in these
u
instructions has been measured in accordance
with a standardised measuring procedure
specified in EN 60745-1 and
EN ISO 11680-1 and can be used to make
equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
: < 2.5 m/s
2
h,W
(1.712 m/s )
2
: < 2.5 m/s
2
h,W
(1.315 m/s )
2
1.5 m/s
2