Nibe RMU 40 Installateurhandbuch Seite 16

GB
Menu 1 - temperature
Setting the temperature (without room sensors
activated):
Setting range: -10 to +10
The display shows the set values for heating (curve offset).
To increase or reduce the indoor temperature, increase
or reduce the value on the display.
Use the arrow buttons to set a new value. Confirm the
new setting by pressing the OK button.
The number of steps the value has to be changed to
achieve a degree change of the indoor temperature de-
pends on the heating unit. One step for under floor
heating whilst radiators may require three.
Setting the desired value. The new value is shown on the
right-hand side of the symbol in the display.
Set the temperature (with room sensors installed
and activated):
Setting range: 5 - 30 °C
The value in the display appears as a temperature in °C
if the heating system is controlled by a room sensor.
To change the room temperature, use the arrow buttons
to set the desired temperature in the display. Confirm
the new setting by pressing the OK button. The new
temperature is shown on the right-hand side of the
symbol in the display.
Caution
An increase in the room temperature can be
slowed by the thermostats for the radiators or
under floor heating. Therefore, open the thermo-
stat valves fully, except in those rooms where a
cooler temperature is required, e.g. bedrooms.
16
TIP
Wait 24 hours before making a new setting, so
that the room temperature has time to stabilise.
Menu 2 - temporary lux
Setting range: 3, 6 and 12 hours and mode "off"
When hot water requirement has temporarily increased
this menu can be used to select an increase in the hot
water temperature to lux mode for a selectable time.
Caution
If comfort mode "luxury" is selected in the heat
pump menu 2.2 no further increase can be car-
ried out.
The function is activated immediately when a time period
is selected and confirmed using the OK button. The time
to the right displays the remaining time at the selected
setting.
When the time has run out the menu returns to "from"
mode.
Select "off" to switch off temporary lux .