Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b) Flight Battery
Attention!
Never leave the flight battery connected to the quadrocopter when you are not using it (e.g.
during transport or storage). Otherwise, the LiPo flight battery may be deep-discharged
and is thus destroyed and rendered useless! There is also a danger of malfunction due to
interferences. The rotors could start up inadvertently and cause damage or injury.
• Never damage the rechargeable battery. Damaging the casing of the rechargeable battery
might cause an explosion or a fire! Unlike conventional batteries/rechargeable batteries (e.g.
AA or AAA type), the casing of the LiPo rechargeable battery does not consist of a thin sheet
but rather a sensitive plastic film only.
• Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the
product into fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you are not using the product. Due to the
rechargeable battery technology being used, you do not need to discharge the rechargeable
battery first.
• Never charge the rechargeable battery of the product unattended.
• Never charge the LiPo flight battery immediately after use. Always leave the LiPo flight
battery to cool off first (at least 5 - 10 minutes).
• Charge the LiPo flight battery after removing it from the quadrocopter and only use the
supplied USB-LiPo-charger.
• Only charge intact and undamaged batteries. If the outer isolation of the rechargeable battery
is damaged or the battery is deformed or bloated, it must not be charged. In this case, there
is immediate danger of fire and explosion!
• Place the flight battery on a fire-resistant surface for charging (e.g. a plate). Keep a distance
to flammable objects (use USB extension cable if required).
• As the charger and the rechargeable LiPo flight battery both heat up during the charging
procedure, it is necessary to ensure sufficient ventilation. Never cover the charger or the
flight battery!
• Never leave LiPo batteries unattended while charging them.
• Remove the flight battery from the charger when it is fully charged.
• The charger is intended for dry indoor use only. The charger and the flight battery must not
become damp or wet.
• There is the risk of fire or explosion by the rechargeable battery in case of error. LiPo batteries
specifically react very strongly at moisture and oxygen due to the chemicals contained in
them! Do not expose the charger, flight battery or quadrocopter to high/low temperatures or
to direct solar radiation.
Declaration of Conformity (DOC)
The manufacturer hereby declares that this product conforms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Select a language by clicking on a flag symbol and enter the product order number
in the search box. You can then download the EU declaration of conformity in PDF
format.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from
the product.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used
batteries/rechargeable batteries. Disposing of them in the household waste is
prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals
involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable)
batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
a) General
TX Transmission frequency ...................... 2.4 GHz (2450–2480 MHz)
TX Transmission power ............................ <20 dBm
TX Transmission range ............................. 60 m
VTx Transmission frequency .................... 5.8 GHz (5725–5880 MHz)
VTx Transmission power .......................... 25 mW
VTx Transmission range ........................... 100 m
b) Race copter
Abmessungen (L x B x H) ......................... 82 x 82 x 41 mm
Main rotor diameter .................................. 32 mm
Motor ........................................................ 615 brushed coreless
Functions .................................................. Go up/down, forward/backward, turn left/right,
Number of speeds .................................... 2
Flight time ................................................. approx. 4 minutes
Camera video resolution/frame rate ........... 600 TVL / 50 fps (PAL), 60 fps (NTSC)
Race timer function ................................... Setting by DIP switch, signal transmission
Steering .................................................... nick, roll, yaw, motor
Weight ...................................................... 22 g (without battery)
c) Transmitter
Operating voltage ..................................... 3 x 1.5 V battery type AAA
Dimensions (W x H x D) ........................... 110 x 68 x 57 mm
Weight ...................................................... 61 g (without battery)
d) Rechargeable battery
Input voltage ............................................. 5 V/DC (via USB)
Rechargeable battery and voltage ............. LiPo 3.7 V
Capacity .................................................... 300 mAh
Charging time ........................................... approx. 30 min.
Weight ...................................................... 6.8 g (rechargeable battery only)
e) USB charger
Input voltage ............................................. 5 V/DC (via USB)
Output voltage .......................................... 5 V/DC
Input current ............................................. min. 500 mA
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE.
left/right side flying, 360º flip, headless mode,
stabilize/manual mode
by IR-emitter
*1590238_v2_0917_02_hk_ss_de_en
Werbung
