Specifications - Makita N5900B Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
2-1. Wing nut
2-2. Bevel scale plate
3-1. Base plate
3-2. Cutting line
4-1. Lock button / Lock-off button
4-2. Switch trigger
5-1. Shaft lock

SPECIFICATIONS

Max. Cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN60745:
Explanation of general view
5-2. Wrench
6-1. Hex bolt
6-2. Saw blade
6-3. Outer flange
6-4. Inner flange
7-1. Side grip
10-1. Rear handle
10-2. Front grip
Model
Blade diameter
at 90°
at 45°
at 50°
-1
)
Overall length
Net weight
Safety class
noise level determined
ENE028-1
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
ENF002-2
Vibration
The vibration
determined according to EN60745:
Work mode : cutting wood
ENF100-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
ENG905-1
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
10-3. Base
11-1. Wing nut
11-2. Guide rule
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
N5900B
235 mm
85 mm
60 mm
53 mm
4,100
380 mm
7.2 kg
/II
) : 89 dB(A)
pA
) : 100 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s
h,W
2
2
) : 2.5 m/s
h,M
2
ENG900-1
vector sum)
or less
ENG901-1