Quick Start - Klarstein AeroDry 10 Bedienungsanleitung

EN
32

QUICK START

Press the POWER key to turn the dehumidifier on and off.
Select the TIMER key, then use the UP and DOWN keys to adjust the
timer (1-24 hours, start/stopping timer).
In Power on mode the set number will represent the number
of hours the unit will run for before turning off. This will remain
unaffected if the unit goes in to defrost mode or the tank is emptied
and than reinserted.
In Standby mode the set number represents the period in hours after
which the unit will start. To cancel start/stop mode press the TIMER
key again.
The SMART mode is designed for maximum convenience
maintaining ideal domestic environment humidity setting of 50-
55 % RH while saving electricity. This is the default mode and is
recommended for most users.
Press UP or DOWN settings keys when the unit is displaying
the current relative humidity to select the desired humidity level.
Humidity level can be set within a range of 35 % RH to 80 % RH in
5 % increments.
• When the humidity setting is finished,the appliance will be
operate according to the target setting humidity. When reaches
the target humidity (the selected humidity is 2 % lower than the
user selected humidistat setting), the compressor stops running,
the fan continues running for five minutes and then is stopped. The
swing will be shut down, but the display retains.
• Keep this statues for 30 minutes, the swing and the fan open, the
fan is running to test the current humidity,when reaches the setting
value, the compressor starts running. If the current humidity can
not reach the setting value, fan will be stopped after 5 minutes,
swing shut down, again to keep this status for 30 minutes, and in
circulation.