Fold Up The Wheelchair; Pushbar; Transport In The Car - Vermeiren Eclips XXL Gebrauchsanweisung

2.11 Fold up the wheelchair

L L L L
CAUTION:
Chance of pinching – Do not place fingers between the components
of the wheelchair.
1. When the pushbar is available, remove the pushbar.
2.
Remove the footrests (see § 2.3).
3.
Remove the seat and backrest cushions.
4. Take the tubes of the seat and move these upwards.
5. Push on the hand-grips to fold up the wheelchair further.

2.12 Pushbar

L L L L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L L L L
WARNING:
Risk of injury - When equipped with the pushbar, the pushbar shall
always be mounted (→ to increase the stability of the back).
The pushbar will be delivered for some seat widths. The pushbar increase the stability of the
back and offer you the possibility of pushing the wheelchair by an attendant. To do this, use
the pre-mounted handles.
As there are different pushbar for different seat widths, take care that no tension between the
pushing handles of the back tubes is created.
The mounting of the pushbar is done as follows:
To take off the push pole:
1. Loosen the Philips screw
2. Remove the pushbar from the right and/or left hand-grip.

2.13 Transport in the car

L L L L
DANGER:
Risk of injury – The wheelchair is not suited for use as a seat in a
motor vehicle.
L L L L
WARNING:
Risk of injury – See that the wheelchair is attached properly. So you
can avoid injury from the passengers during collision or sudden braking.
L L L L
WARNING:
Risk of injury – Use for attaching the wheelchair and passenger
NEVER the same seatbelt.
Never use your wheelchair as a seat in an automobile or other vehicle. The wheelchair shall
be marked with following symbol.
1. Secure the pushbar
side to the end of handle
screw
2. Screw gently the Philips screw
thread of the handle
3. Swing the pushbar to the right.
4. Screw gently the Philips screw
thread of the right handle
on the right and/or left hand-grip.
Page 12
Eclips XXL
by fastening the left
with the Philips
in the applicable sunk threads.
.
.
2013-04
into the
into the