Vaude Hogan UL argon 2P Bedienungsanleitung Seite 12

• Zips are always a weak point in a tent's structure. If they get dirty, clean
• Never store your tent when it's wet for a longer period of time. Unpack
• Do not whip out tent poles and snap the sections together. This can
• VAUDE only uses poles from the renowned manufacturers DAC and
• The tent should only be cleaned by hand, never in a washing machine! Use
• When on the road, repair tears in the tent wall with repair tape and seal
• Tent pole shock cords can be retightened if necessary (elasticity can wear
12
GAL_TENT_Hogan_UL_Argon_2P.indd 12
emitted from these materials contain plasticizers that can damage your
tent over time.
them with a (tooth) brush and lubricate them with graphite (pencil lead),
silicon or sewing machine oil. Apply carefully and remove excess oil with a
soft cloth.
it as soon as you arrive and dry it out in a well-ventilated place. To do so,
separate the inner and outer tents or use the poles to create space bet-
ween the two.
damage the pole ends as well as the anodization. Check the poles
regularly for cracks or other potential damage. Wash the poles and use
silicon spray at any sign of corrosion (from salt water, for example)
Yunan. These tend to become slightly bent with use, helping to reduce
fracturing. Please do not attempt to bend these back into shape.
Although aluminum is extremely flexible this might damage or even
break the poles. Every VAUDE tent comes with a Pole Doctor or repair
sleeve. If a tent pole breaks while out on a trip, simply slide the repair
sleeve over the broken section and then use tape to attach it (z).
a soft cloth and luke warm water. Detergents or cleaning agents may harm
the tent's coating and waterproofing.
Use a brush to rub nikwax Tech wash in a 1:4 ratio with water on stub-
born stains. Follow up with nikwax Tent & gear Solarproof waterproo-
fing, applying generously to the area cleaned.
from the inside with a PU or silicon seam sealer. The seam should however
be correctly repaired as soon as possible in order to prevent further
tearing. Please contact your retailer to do this.
out in very cold conditions or due to aging). To do this first remove the end
cap and then untie the knot in the cord. Retie the knot further up the cord
and replace the cap.
08.08.2011 11:50:30