Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(32) Remove lattice screen, pad and media containers from the filter canister. Thoroughly rinse
medium in the medium container under running luke-warm water – until the water is clear.
The white filter pad provides mechanical fine filtration. Since adhering dirt particles cannot be
rinsed out completely the filter pad must not be used more than once. Insert new pad (order no.
2616265). The same applies to adsorptive filtering with an active carbon pad. After excessive use
the collected pollutants may detach again. Therefore the pads may only be used for short periods
(1 – 2 weeks). Insert new active carbon pad (order no. 2628260).
The blue filter pad (included once in the set, order no. 2616260) may be re-used two to three times.
Wash gently under running water before re-inserting so that some of the resident bacteria are re-
tained.
When replacing SUBSTRATpro about one third of the used filter medium should be mixed with
Tip:
the new material to speed up bacteria recolonization.
(33) Wash out filter canister, then insert media containers again. Press the bottom container down
to the supporting bars and ensure that the following containers fit smoothly. The pipe
openings of the media containers must lie on top of each other, sealed with the rubber seals.
When using active carbon filtration the active carbon pad (order no. 2628260) is inserted under the
handle of the top medium container.
Then place new filter pad
tracted. Place lattice screen on top.
The white filter pad must not be inserted under the handle of the medium container.
Attention:
Check that the sealing gasket on the filter head is in the correct position and clean, place head on
canister, close EZ clips and place the filter at bottom of the cabinet.
(34) Connect hose adapter and lock by retracting lever.
All hose connections must be checked at regular intervals for correct fitting.
Note:
(35) The priming support is activated by pressure on the pump so that the canister fills with water
again. Then start up filter by connecting lead to the mains.
C°
Thermofilter:
(36)
First disconnect mains plug of the heater
Clean filter media as described above. Wash out media containers. Occasionally clean off mull
deposits from the heater spiral with a soft brush.
Do not bend the heater spiral. Do not submerge the filter canister. Protect heater
Attention:
electronics from splashes.
(37) Then re-insert media containers, taking care not to place the pipe opening above the hea-
ter connection.
When the installation is completed, activate the priming support and then start up the filter
pump with the mains connection.
Do not connect the heater to the mains before the filter is operating smoothly.
Attention:
Never operate the heater when dry.
the topmost medium container, ensure that the handle is first re-
on
and then mains plug of the pump.
Werbung
