Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C°
Thermofilter: Heater installation
(8) Fix the temperature sensor of the thermostat with two clamps and suction caps in the
aquarium in such a way that it is positioned below the water surface at all times. Do not install
near the filter outflow.
(9) The thermostat can be placed on the aquarium hood or fixed with the enclosed velcro tape.
Protect against splashes and moisture.
(10) Then direct the control cable from the filter canister to the thermostat and connect the plug
until you hear it snap into place. An extension of 1.5 metres for the control cable is available
at spezialised acquatic retailers under order no. 7676290.
Do not yet plug in the heater's mains connection.
Attention:
Filling With Filter Media
Removing adapter.
(11) Pull adapter lever forward as far as it will go, simultaneously pressing the red safety catch to
the right. The hose connections are now closed and the adapter clicks from its safety holder.
Opening filter.
(12/13) Flip out EZ clips, push upwards and lift off filter head.
(14) Remove lattice screen and filter pad as well as the media containers individually.
The retractable handles can be extended upwards.
Filling.
Fill the bottom media container with EHFIMECH only so far that the blue filter pad can be inserted
under the handle.
(15) Fill the second (and third) container with the biological filter medium SUBSTRATpro to just
below the rim.
Do not overfill, do not clog flow-through pipe.
Attention:
(16) Then rinse the filter medium in the container thoroughly under running water while mixing it
through, until the water is clear.
(17) Return the bottom container – with the blue filter pad – to the filter canister and attach the rub-
ber seal to the pipe opening. Press the container firmly down onto the supporting bars to ensure
safe sealing against the canister.
C°
Thermofilter:
(17-1) In the thermofilter version make sure that the pipe openings of the filter containers are not
positioned above the heater connection.
Werbung
