Specifications - Makita HR2010 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Side grip
3-1. Bit shank
3-2. Bit grease
4-1. Bit
4-2. Chuck cover
5-1. Depth gauge

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
5-2. Clamp screw
5-3. Grip base
5-4. Side grip
6-1. Drill chuck
6-2. Chuck adapter
7-1. Commutator
7-2. Insulating tip
Model
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
ENE041-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
ENF002-2
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
7-3. Carbon brush
8-1. Screwdriver
8-2. Brush holder cap
9-1. Lock nut wrench
9-2. Crank cap
10-1. Hammer grease
HR2010
20 mm
13 mm
24 mm
0 - 900
0 - 4,000
302 mm
3.4 kg
/II
2
) : 12.0 m/s
h,HD
2
ENG900-1
ENG901-1