State Of Charge; Leds On Battery; Led On Charger; Assembling The Trimmer - Stihl FSA 56 Gebrauchsanleitung

English
2
4
1
► Insert the plug (6) in a convenient wall outlet (7).
The charger (3) runs a self test. The LED (4) glows green
for about 1 second and then red for about 1 second.
► Lay the connecting cable (5).
► Insert the battery (2) in the guides in the charger (3) and
press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow green and
the battery (2) is being charged.
► If the LED (4) and the LEDs (1) stop glowing: Disconnect
the plug (6) from the wall outlet (7).
Battery is fully charged.
► Remove the battery (2).
6.3

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
44
3
7
6
5
80-100%
60-80%
40-60%
20-40%
0-20%
► If the LED on the right flashes green: Charge the battery.
6.4

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
Malfunction in trimmer or battery.
6.5

LED on Charger

The LED indicates the operating status of the charger.
If the LED glows green, the battery is being charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.

7 Assembling the Trimmer

7.1

Mounting the Deflector

► Switch off the trimmer and remove the battery.
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
7 Assembling the Trimmer
3
2
0458-713-9621-C