Replacing The Lamp; Closing The Door; Installation - Electrolux EN3601AOX Benutzerinformation

Problem
The lamp does not
work.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre.

7.1 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
1.
Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4.
If needed replace the lamp with a light
of similar characteristic and power. It
is suggested to use Osram PARA-
THOM SPECIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the
lamp comes on.

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.

7.2 Closing the door

1.
2.
3.
Cli-
mate
class
SN
N
ST
T
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the
lamp".
2
1
Clean the door gaskets.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 43