Rear Spacers; Electrical Connection; Door Reversibility - Electrolux EN3601AOX Benutzerinformation

44 www.electrolux.com
8.2 Location
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below overhang-
ing wall units. Accurate levelling is ensur-
ed by one or more adjustable feet at the
base of the cabinet.
A
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible after
installation.

8.3 Rear spacers

You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2.
Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
B
4
8.4 Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.

8.5 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.

8.6 Door reversibility

WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
2
1
3