Charger Location; Follow These Steps When Battery Is Installed In Vehicle - Herth+Buss Flash CS70 Bedienungsanleitung

Operating Instruction
and any equipment used near the bat-
tery and charger. Study all of the batte-
EN
ry manufacturer's specific precautions
while charging and recommended rates
of charge.
3.6 Determine the voltage of the battery by
referring to the vehicle owner's manual.
3.7 Make sure that the charger cable clips
make tight connections.

4. Charger Location

WARNING
RISK OF EXPLOSION AND CONTACT
WITH BATTERY ACID.
NOTE: This is a Class A product for industrial
use only, for use with professional equip-
ment with a total rated power greater than 1
kW. In a domestic environment, this product
may cause radio interference, in which case
the user may be required to take adequate
measures.
4.1 Locate the charger as far away from the
battery as the DC cables permit.
4.2 Never place the charger directly above
the battery being charged; gases from
the battery will corrode and damage the
charger.
4.3 Do not set the battery on top of the
charger.
4.4 Never allow battery acid to drip onto the
charger when reading the electrolyte
specific gravity or filling the battery.
www.herthundbuss.com
5. Follow these steps when
battery is installed in vehicle
WARNING
A SPARK NEAR THE BATTERY MAY CAUSE
A BATTERY EXPLOSION.
TO REDUCE THE RISK OF A SPARK NEAR
THE BATTERY:
5.1 Position the AC and DC cables to reduce
the risk of damage by the hood, door and
moving or hot engine parts.
NOTE: If it is necessary to close the hood
during the charging process, ensure that
the hood does not touch the metal part
of the battery clips or cut the insulation
of the cables.
5.2 Stay clear of fan blades, belts, pulleys
and other parts that can cause injury.
5.3 Check the polarity of the battery posts.
The POSITIVE (POS, P , +) battery post
usually has a larger diameter than the
NEGATIVE (NEG, N, -) post.
5.4 Determine which post of the battery is
grounded (connected) to the chassis.
5.5 For a negative-grounded vehicle, con-
nect the POSITIVE (RED) clip from the
battery charger to the POSITIVE (POS, P ,
+) ungrounded post of the battery. Con-
nect the NEGATIVE (BLACK) clip to the
vehicle chassis or engine block away
from the battery. Do not connect the clip
to the carburetor, fuel lines or sheet-me-
tal body parts. Connect to a heavy gauge
metal part of the frame or engine block.
5.6 For a positive-grounded vehicle, connect
95950004
26