Control Panel - Herth+Buss Flash CS70 Bedienungsanleitung

Operating Instruction

9. Control Panel

EN
CONNECTED (yellow/orange) LED
The CONNECTED LED will light when the
battery is properly connected.
CHARGING (yellow/orange) LED
When charging begins, the CHARGING
LED will light.
CHARGED (green) LED
The CHARGED LED will light when the
charger has gone into maintain mode.
and
Use these buttons to select the amount of
time or voltage, depending on the display
function selected.
(Start/Stop) Button
This is the start and stop button for
all modes.
www.herthundbuss.com
(UP and DOWN) Buttons
Digital Display
The Digital Display gives a digital indication
of voltage, amperes or time, depending on
the display function chosen.
Display Button
Use this button to set the function of the
digital display to one of the following:
VOLTS (Voltmeter)
The voltmeter indicates the voltage at
the battery terminals. If the reading is
12.8 volts or more, the battery is char-
ged.
AMPS (Ammeter)
The ammeter indicates the amount of
current, measured in amps, that is being
drawn by the battery (± 2 amps).
95950004
30