Herunterladen Inhalt Inhalt Diese Seite drucken

Work Area Safety; Battery Charger Safety; Personnel Safety - Herth+Buss ELPARTS 95950005 Bedienhinweis

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating Instruction
Purpose of use
The electronic battery charger can be used
EN
for the following purposes:
charging and supplying power to motor

vehicles;
use on 12V, Wet - Agm - lithium (LiFe-

PO4) batteries;
reprogramming and self-diagnosis.

The electronic battery charger must not be
used for the following operations:
use on batteries other than 12V

use outside the technical specifications

contained in the TECHNICAL DATA table;
use in humid or wet environments, or in

bad weather;
use for any applications other than

stated ones.
IMPORTANT
Read carefully before use

Keep for later reference

The latest version of the Operating/

Fitting instructions is also available
in our online catalogue:
herthundbuss.com/online catalogue
www.herthundbuss.com
95950005

WORK AREA SAFETY

Do not operate the battery charger in

environments containing potentially
explosive atmospheres or inflammable
materials, because sparks may be gene-
rated, which can ignite the due or fumes.
Keep children and bystanders away

from your workplace while operating the
battery charger.
Distractions from other people can cause

you to lose control over the battery char-
ger during use.
Do not inhale any harmful gases that may

be released by the battery of the motor
vehicle while working on the engine.
During connection operations, keep your

face away from the motor vehicle batte-
ry. The battery contains corrosive liquid;
in the event of accidental contact with
your skin or eyes, rinse immediately with
water and seek medical advice.
Do not drop any metal tools on the mo-

tor vehicle battery: it may short-circuit.
Use the battery charger in a dry area,

avoiding humidity.
Technical data:
Operating Instruction

Battery charger safety

Before use, check that the battery charger

has not been damaged, and that there are
no uncovered cables or worn parts.
Do not use the battery charger when

damaged, to avoid the risk of electric
shocks; do not try to open or modify it.
Connect the power supply cable of the

battery charger to the mains socket, ma-
king sure that the mains voltage matches
the voltage stated on the power supply
device. (See TECHNICAL DATA table)
After use, do not leave the battery char-

ger connected to the mains socket for a
long time.
Do not damage the electronic circuit of

the battery charger.

Personnel safety

Stay alert; watch what you are doing. Do

not use the battery charger while tired
ir under influence of drugs, alcohol, or
medications.
Always use the following personal pro-

tective equipment:
safety shoes;

eye protection;

protective gloves against physical agents

Use the battery charger in well-aired, dry

rooms.
Never allow the clips of the clamps

(positive-red and negative-black) to touch
together.
Check that the cables of the battery

charger are kept away from fans, moving
parts and the fuel pipe.
14
15
95950005
Do not wear loose clothing, jewellery or

metal objects when working on the motor
vehicle.
Before replacing the battery charger,

make sure that it has cooled to room
temperature.
Battery charger use and care
Do not put any objects into any slots or

openings on the surface of the battery
charger.
Do not use the battery charger if the case,

the clamps, the cables or the power sup-
ply cable have been damaged, if it gives
off unusual smells or too much heat.
Do not modify the battery charger. This

can reduce the effectiveness of safety
measures and increase operator risk.
Have the battery charger repaired only

through a trained repair person and only
using original replacement parts.
Before carrying out any operations, turn

off the lights of the motor vehicle and cut
out any running accessories.
Always check that the voltage of the

battery charger matches the voltage of
the motor vehicle's system, to prevent
explosions, damage to the motor vehic-
le, the battery charger and people.
Always connect the output lead with

red clamp (+) to the positive post of the
battery, and the output lead with black
clamp (-) to the motor vehicle's chassis.
Never reverse polarity; reversed polari-

ty can cause explosions or damage to
the motor vehicle, the battery charger
and people.
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis