Troubleshooting - Grundig GKN 16835 Bedienungsanleitung

7. Troubleshooting

Check this list before contacting the service. Doing so will save you time
and money. This list includes frequent complaints that are not related to
faulty workmanship or materials. Certain features mentioned herein may
not apply to your product.
The refrigerator is not working.
•
The power plug is not fully settled. >>> Plug it in to settle completely
into the socket.
•
The fuse connected to the socket powering the product or the main
fuse is blown. >>> Check the fuses.
Condensation on the side wall of the cooler compartment (MULTI
ZONE, COOL, CONTROL and FLEXI ZONE).
•
The door is opened too frequently >>> Take care not to open the
product's door too frequently.
•
The environment is too humid. >>> Do not install the product in
humid environments.
•
Foods containing liquids are kept in unsealed holders. >>> Keep the
foods containing liquids in sealed holders.
•
The product's door is left open. >>> Do not keep the product's door
open for long periods.
•
The thermostat is set to too low temperature. >>> Set the thermostat
to appropriate temperature.
Compressor is not working.
•
In case of sudden power failure or pulling the power plug off and
putting back on, the gas pressure in the product's cooling system
is not balanced, which triggers the compressor thermic safeguard.
The product will restart after approximately 6 minutes. If the product
does not restart after this period, contact the service.
•
Defrosting is active. >>> This is normal for a fully-automatic
defrosting product. The defrosting is carried out periodically.
•
The product is not plugged in. >>> Make sure the power cord is
plugged in.
•
The temperature setting is incorrect. >>> Select the appropriate
temperature setting.
•
The power is out. >>> The product will continue to operate normally
once the power is restored.
The refrigerator's operating noise is increasing while in use.
•
The product's operating performance may vary depending on
the ambient temperature variations. This is normal and not a
malfunction.
E
CZ
SK
25