Specifications - Makita BDF442 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Lamp
4-1. Reversing switch lever
5-1. Speed change lever
6-1. Adjusting ring
6-2. Graduation

SPECIFICATIONS

Capacities
-1
No load speed (min
Net weight (with type of battery cartridge)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
For Model BDF442
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745:
Work mode: Drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-3. Pointer
7-1. Sleeve
8-1. Bit holder
8-2. Bit
9-1. Groove
9-2. Screw
9-3. Hook
11-1. Limit mark
12-1. Rear cover
Model
Steel
Wood
Wood screw
Machine screw
High (2)
)
Low (1)
Overall length
Rated voltage
) : 71 dB(A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
2
BDF442
13 mm
38 mm
6 mm x 75 mm
0 - 1,400
0 - 400
197 mm
1.7 kg
D.C. 14.4 V
ENE034-1
For Model BDF452
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
ENG104-1
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode: Drilling into metal
Vibration emission (a
ENG202-3
Uncertainty (K) : 1.5 m/s
sum) The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
3
12-2. Screws
13-1. Recessed part
13-2. Spring
13-3. Arm
14-1. Carbon brush cap
15-1. Hole
15-2. Carbon brush cap
M6
) : 70 dB(A) or less
pA
Wear ear protection
total value (tri-axial
) : 2.5 m/s
h,D
2
BDF452
13 mm
38 mm
10 mm x 89 mm
M6
0 - 1,500
0 - 400
197 mm
1.6 kg
D.C. 18 V
ENG103-3
ENG202-3
vector sum)
2
or less
ENG901-1