Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita DF330DWLE Bedienungsanleitung

ENGLISH
1-1. Button
1-2. Battery cartridge
2-1. Switch trigger
3-1. Lamp

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
Noise
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-1:
Sound pressure level (L
The noise level under working may exceed 85 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745-2-1:
Work mode: Drilling into metal
Vibration emission (a
EC-DECLARATION OF CONFORMITY
Model; DF330D
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014
Directives, 2004/108/EC, 98/37/EC.
000230
Tomoyasu Kato
Explanation of general view
4-1. Reversing switch lever
5-1. Speed change lever
6-1. Pointer
6-2. Adjusting ring
Model
Steel
Wood
Wood screw
Machine screw
High (2)
)
Low (1)
Chuck capacity
Overall length
Net weight
Rated voltage
) : 70 dB(A) or less
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
in accordance with Council
CE2008
Director
ENE034-1
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
ENG103-1
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to drill safety rules. If you use this power tool
ENG202-1
unsafely or incorrectly, you can suffer serious
personal injury.
sum)
1. Wear
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
ENH102-8
3. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
only when hand-held.
3
6-3. Graduation
7-1. Sleeve
DF330D
10 mm
21 mm
5.1 mm x 63 mm
M6
0 - 1,300
0 - 350
0.8 mm - 10 mm
189 mm
1.0 kg
D.C. 10.8 V
ear protetors with
GEB001-3
impact drills.