Transportation Information; Description Of Unit; Set-Up And Initial Commissioning; Scope Of Delivery - Bosch VLH 4345 LA Originalbetriebsanleitung

5.4

Transportation information

The lifting platform is packaged as follows on delivery:
Packing unit Dimensions
1 x crate 320 x 114 x 60 cm
1 x package (runways) 500 x 58 x 40 cm
The user must provide a fork lift truck for in-house
transportation. The center of gravity and lashing points
are marked on the packaging.
Fig. 1: Center of gravity of consignment (example)
5.5

Set-up and initial commissioning

The lifting platform is only to be started up by Bosch
customer service or an authorized service agent. Initial
commissioning of the lifting platform is described in the
installation instructions. Acceptance must be performed
by a qualified person after initial commissioning.
5.6

Scope of delivery

Designation
Lifting platform VLH 4x45 LA, complete
Polymer rests 60 mm for wheel-free scissor lift
Polymer rests 90 mm for wheel-free scissor lift
Original operating instructions
Test log book (en)
5.7

Special accessories

Information on special accessories (e.g. overhead light
barrier, turntables, alternative longer drive-on ramp,
additional drive-off ramp) can be obtained from your
Bosch franchized dealer.
Robert Bosch GmbH
Product description | VLH 4x45 LA | 27
5.8

Description of unit

5.8.1 Outline
Weight
The VLH 4x45 LA is a 4-column lifting platform with
1600 kg electro-hydraulic drive. Fig. 2 shows the principal
components.
Fig. 2: Lifting platform
1 Operating unit
2 Hydraulic unit
3 Attachment points for sensors (special accessory)
4 Runway
5 Cross member
6 Drive-on ramp with roll-off guard
7 Sliding plate for wheel alignment
8 Wheel-free scissor lift
Order no.
9 Turntable (special accessory)
Refer to
10 Fillers
rating plate
11 Roll-off guard (optionally left/right)
1 692 872 362
1 692 872 363
The lifting platform is provided with one control
1 692 826 036
column, three secondary columns and two runways.
1 689 977 085
The control column contains the operating unit (1) and
a hydraulic unit (2).
The columns are connected in pairs by cross
members (5). The runways (4) rest on the cross
members. The runway on the right can be moved
sideways to adjust the spacing between the runways.
When the lifting platform is lowered, a motor vehicle
can be driven onto the runways by way of the drive-on
ramp (6). Roll-off guards (6, 11) stop the vehicle rolling
off the runways.
en
|
1 689 989 097 2017-07-19