Maintenance Schedule - Bosch VLH 4345 LA Originalbetriebsanleitung

8.4.2

Maintenance schedule

Component
x x x Stickers
x x x Drive-on ramp and
roll-off guards
x x x Wiring
x x x Hydraulic system
x x x Detent pins
x x Exposed surfaces
and edges
x x Exposed surfaces
and edges
x x Suspension cables
and pulleys
x x Slack cable safety
system
x x Cable break safety
device
x Hydraulic unit
x Moving
components
x Shear connectors
Robert Bosch GmbH
Action
Visual inspection:
All stickers must be affixed and
clearly legible.
Visual inspection:
Components must not be
damaged.
Visual inspection:
No damage to insulation.
Visual inspection:
No escape of fluid.
Functional test:
Detent pins must extend and
retract properly.
Cleaning:
Clean all contaminated surfaces
and apply preservative agent if
applicable.
Paintwork care:
Sand down paintwork
blemishes with sand paper
(grain size 120) and touch
up with the appropriate RAL
shade.
Visual inspection:
Components must not be
damaged or worn.
Typical examples of cable
damage: Individual wire breaks,
corrosion, kinking, constriction,
flattening, looping, tangling.
Pay particular attention to
cables in area of threaded end
pieces (under end plate).
Functional test:
Actuate slack cable switch.
Functional test:
Check freedom of movement
of locking mechanism.
Check fluid level in tank.
Dipstick must be immersed in
fluid (max. 5 mm) when lifting
platform is fully lowered.
Top up with specified organic
hydraulic fluid if necessary.
Check lubrication:
Lubricate all moving
components as per
lubrication chart.
Check strength.
Re-tighten to a torque of 60 Nm
if necessary.
Decommissioning | VLH 4x45 LA | 37
9. Decommissioning
9.1 Temporary shutdown
In the event of lengthy periods of non-use:
¶
Disconnect the VLH 4x45 LA from the mains.
¶
Lock the master switch.
9.2 Change of location
¶
Disconnect electrical and pneumatic connections.
¶
The VLH 4x45 LA is only ever to be transported in
the original or equivalent packaging.
¶
If the VLH 4x45 LA is passed on, all the documentation
included in the scope of delivery must be handed over
together with the unit.
¶
Heed the notes on initial commissioning.
9.3 Disposal and scrapping
9.3.1 Substances hazardous to water
!
Oils and greases as well as refuse containing oil and
grease (e.g. filters) represent a hazard to water.
1. Substances hazardous to water must not be allowed
to enter the sewage system.
2. Substances hazardous to water must be disposed of
in accordance with the applicable regulations.
9.3.2 VLH 4x45 LA and accessories
1. Disconnect electrical and pneumatic connections.
2. Dismantle the VLH 4x45 LA and sort out and dispose
of the different materials in accordance with the
applicable regulations.
VLH 4x45 LA, accessories and packaging
should be sorted for environmental-friendly
recycling.
¶
Do not dispose VLH 4x45 LA into household
waste.
Only for EC countries:
The VLH 4x45 LA is subject to the European
directive 2012/19/EC (WEEE).
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
¶
Make use of the local return and collection
systems for disposal.
¶
Proper disposal of VLH 4x45 LA prevents
environmental pollution and possible health
hazards.
en
|
1 689 989 097 2017-07-19