Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto the con-
trols protruding from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw 4 brackets on the bottom of hob(see picture) after installation.
Adjust the bracket position to suit for different table top thickness.
Connecting the hob to the mains power supply
This hob must be connected to the mains power supply only by a suitably qualified person.
Before connecting the hob to the mains power supply, check that
• the domestic wiring system is suitable for the power drawn by the hob.
• the voltage corresponds to the value given in the rating plate
• the power supply cable sections can withstand the load specified on the rating plate.
To connect the hob to the mains power supply, do not use adapters, reducers, or branching devices, as they
can cause overheating and fire. The power supply cable must not touch any hot parts and must be positioned
so that its temperature will not exceed 75˚C at any point.
The power supply should be connected in compliance with the relevant standard,or a single-pole circuit
breaker.the method of connection is shown below
40