Installation; Selection Of Installation Equipment - Klarstein 10029241 Anschluss- Und Anwendungshinweise

Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state automatically and display cor-
responding protective codes:
Problem Possible Cause
F3/F4 Temperature sensor of the induction coil
fail.
F9/FA Temperature sensor of the IGBT failure.
E1/E2 Abnormal supply voltage
E3 High temperature of the induction coil
temperature sensor.
E5 High temperature of the IGBT temperture
sensor.

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface mate-
rial to avoid larger deformation caused by the heat radiation from the hotplate. As shown below.
L (mm) W (mm)
590 520

Installation

H (mm) D (mm)
55 58
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether powersupply is
normal. Power on after the power supply
is normal.
Please contact the supplier.
Please restart after the induction hob cools
down.
A (mm) B (mm)
560 490
X (mm)
50 mini
38