Switch Over Transmitter Power - Motorola MR 11 S-C Bedienungsanleitung

923991 19.10.1999
GB
tones are switched off temporarily is determined by the radio's programming.
This may be none, one or any group of the following items:
Keyclick and confirmation tone
Acoustic calling and acknowledge tone
Error tone
Emergency call warning signal
Error tone and battery warning tone
Loudspeaker completely muted
Keyboard and display lighting
To cancel the temporary deactivation, switch the radio off and then back on.
Switch Over the Transmitter Power
It is possible to program different transmitter powers of the radio channel-
dependently or on all channels. Two of four adjustment values can be stored
per channel as "high transmitter power" and "low transmitter power". It is
also possible to program the same value for both powers on one or more
channels, a power switching on just one channel is then possible.
When the radio is switched on normally, the transmitter operates with the
values "high transmitter power".
To switch to the "low transmitter power" values, press the call key I (item 2)
and the plus key (item 9) together, with the radio switched off and then press
the On/Off key (item 5). These key combinations are only really necessary in
the hand-held radio PR 11 S-E (without display) but also work in all other
radios.
Switch the radio off and back on to switch from "low transmitter power" to
"high transmitter power".
If required, a low power value can also be programmed for the "high trans-
mitter power" programming item and a high power value for the "low trans-
mitter power" programming item. The radio then operates after normal
switching on with the low transmitter power and after switching on with
pressed keys with the high transmitter power.
82
10:28 Uhr Seite 82