KKT KOLBE EBD8501ED Benutzerhandbuch Seite 35

Care and cleaning
Removal of oven door
Note: Removal of the door may be necessary for better
access to the oven interior or if the glass panels need to
be removed and cleaned.
• Open the door fully (Figure 1).
• Open the lever A completely on both the left and right
hinges (Figure 2).
• Hold the door as shown in (Figure 3) approximately a
30 degree angle in an upwards direction.
1
Removal of glass door panes
Note: In the occurence where grime may be noticed
between the glass panes, the two inner glass panes can
be accessed after door is removed as explained on the
previous page.
• After door removal, place door on a stable surface on
soft material to protect the glass from damage orscrat-
ching.
• Locate the two philips head screws at the bottom edge
of the door. Remove these two screws and putaside
for re-fitting. Carefully remove the inner glass pane by
lifting upwards and then toward you torelease from the
top metal strip at the top of the door.
• Locate the two philips head screws at the top edge of
the door. Remove these two screws being carefulnot
to lose the two brass spacers also in place in the top
metal strip and put aside for re-fitting. Gentlyslide the
middle glass pane out of the door channel.
• Clean the glass panes with an appropriate cleaner. Dry
thoroughly, and place on a soft surface.
• Now you can also clean the inside of the outer glass.
• Re-fit the glass panes in reverse order to re assemble
the door. Care should be taken ensuring thepanes are
placed back the way they were removed as they are
coated with a reflective coating to retainthe heat within
the oven. Also pay atention of the rubber gaskets for
both inner glass panes that they arenot crimped or
placed incorrectly to ensure the glass is securely held
in place.
A
B
2
• Gently close the door (Figure 3.) until left and right
hinge levers A (Figure 2) are hooked to part B (Figure2)
of the door.
• Withdraw the hinge hooks from their location following
arrow C (Figure 4)
• Rest the door on a soft surface, to reduce risk of dama-
ge to the door.
• To replace the door, repeat the above steps in reverse
order.
3
Cleaning the door glass
• Clean the glass door using non-abrasive products or
sponges and dry it with a soft cloth.
• Do not use the oven without the inner door panes fitted
correctly. When re-fitting inner glass door panesen-
sure they go back in facing the same way they came
out. The doors are coated with a very slightreflective
coating to reflect the heat back into the oven cavity and
keep the outer door cooler to touch.
• Do not use harsh abrasive cleaners or sharp metal scra-
pers to clean the oven door glass since they canscratch
the surface, which may result in shattering of the glass.
C
4
35