Troubleshooting - Lightmaxx Vega PAR FX II Bedienungsanleitung

Troubleshooting:

The following overview is intended as an aid to rapid troubleshooting. If you are unsure,
contact the manufacturer, the dealer or appropriate specialist personnel. Never open the
device by yourself!
Symptoms
No Function
No Reaction in DMX Mode
No Reaction from Remote
Control
If the troubleshooting above has not been successful, please contact our service staff.
You can fi nd the contact details at www.musicstore.de.
Cleaning:
Regular cleaning of the device from dirt and dust increases the shelf life of the product. Always
disconnect the unit from the power supply while cleaning. Optical lenses should be cleaned
with a dry microfi ber cloth. This also optimises the light output. Never clean the
device wet! Ventilation shafts and openings should always be free of dust and dirt. Compres-
sed air sprays are ideal for cleaning the dirts off.
24
Warning! (Fault during data transmission)
Never connect the DMX input or output to audio devices such as power
amplifi ers or mixing consoles!
DMX cables enable interference-free operation and the highest possible
transmission reliability of signal data. Do not use microphone cables.
Troubleshooting
Check the network connection and its fuse.
Check the cable connections
Check your DMX address settings
If available, try an alternative DMX controller
Change the battery in your remote control
Make sure that the IR transmitter and receiver are within
a short and clear distance of each other.