Werbung
CH9
Drawing
Scanning
speed
CH10
Display dot
CH11
Color setting
Color change
CH12
speed
TROUBLE SHOOTING
1. If the power indicator is off and the laser doesn't work, please check the power supply and the input.
2. In Stand-Alone operation, if the power supply indicator is ON and sound active indicator is OFF, but the
laser doesn't work.
A. Because sound is too small and cannot activate laser running, please increase the music volume or
increase audio sensitivity on rear panel.
B. Please check if unit has been set up in slave mode, or DMX mode.
3. In Master-Slave operation, slave units don't function, please check as below.
A. Make sure there's only one master in the chain, and the others are set in slave mode.
B. Make sure to control the units with DMX controller.
C. Make sure to use a good quality power cable and XLR connector.
4. In DMX operation, the unit can't be controlled by the DMX console, but the DMX signal indicator is
flashing, please make sure the DMX console and unit have the same channel.
5. If the output beam direction above is unusual, please restart the unit.
6. If the unit is fail, please turn off the unit, and then turn on again after 5 minutes.
After trying the above solution you still cannot sort out the problem, please contact your dealer or our company for
service.
192~255
0~255
0~127
128~255
0~24
25~199
200~224
225~255
All the colors together changing alternatively in one pattern
0~255
www.musicstore.com
Manual zooming (+/-) from slow to fast
Auto drawing from slow to fast
Choose sanning speed from slow to fast
Choose the length of dot
Normal color
Choose every single color
Every single color changing one by one
Adjust color changing speed from slow to fast
11
Werbung
