Using The Lathe Functions; Diameter Display - Sony LH51 Bedienungsanleitung

5-8. Using the Lathe Functions

5-8-1. Diameter display

The value of the cutting direction decreases for the cross slide direction (X axis) in the diameter
display. Pay particular attention to setting the diameter display (ø) for the necessary resolution
and setting the polarity when following the instructions provided in "5-1-1. Setting the resolution
and polarity" and "5-1-2. Setting the display resolution" in section "5-1. Initial Settings".
Center lathe
＋Z
＋X
Z
X
Standard coordinate system
Turret lathe
＋X
＋Z
Z
X
Standard coordinate system
Face lathe
Z
X
Standard coordinate system
＋Z
＋X
49