Applying Power And Resetting - Sony LH51 Bedienungsanleitung

5-2. Applying Power and Resetting

22
After installation, connections and setting of the resolution have been completed, begin
machining as described in the procedure below.
1
Set the power switch to ON
Set the POWER switch to ON.
" " will be displayed.
If " " starts blinking or "
2
Press the RESET key.
The first time the RESET key of X- or Z-axis is pressed after the power is turned on, the previously
displayed value (Incremental mode when the power is turned on) is displayed. After this, zero is
displayed only for the reset axes. The unit is set to Incremental mode when reset.
However, if the power was turned off after canceling the BH/ARC mode during bolt hole circle or
simple R cutting execution, the value displayed when the
displayed when the power was turned off.
3
Start positioning.
When the machine table is moved, the displacement is displayed. The minus (–) sign appears
depending on the direction of movement of the table.
Example: Displacement of 10 mm in the plus (+) direction on the X-axis
and 5 mm in the minus (–) direction on the Z-axis.
Note
In the example, the resolution is set to 0.0005 mm.
" lights in the display, refer to "8. Alarm Display".
ABS INC
Ø
ABS INC Ø
Incremental mode
ABS INC Ø
ABS INC Ø
ABS INC Ø
ABS INC Ø
RESET
X
RESET
Y
RESET key is pressed is not the value
Reset key
RESET
X
RESET
Y
RESET
X
RESET
Y