Selecting Addition Display/Single Axis Display (Lh52 Only); Selection Of Absolute Zero Point Of Scale (Lh52 Only) - Sony LH51 Bedienungsanleitung

5-1-7. Selecting addition display/single axis display (LH52 only)

5-1-8. Selection of absolute zero point of scale (LH52 only)

Z
0
or
20
Initial Setting Mode for Setting the Z-Axis Addition Display Operation for Z-axis only.
• After the 5-1-4 operation, press an axis selector key to select this mode.
• The setting can be changed with the
Setting Display
Note
• Addition display is only possible in the Z-axis display section.
• With addition display, the display resolution is the greater of the display resolution set by the
connected axes. So in the double counting display mode, be sure to set the addition display
previously.
• Set the display mode to "
Z -axis, and Z -axis.
1 2
• The default setting is "
displayed when using this setting.
• Only Z-axis operation is performed
• With 3 axes input, select whether the Z
Z-axis absolute zero point. (This prevents a misoperation when there is an absolute zero point
for both the Z -axis and the Z
1
• After completing the operations in 5-1-7, press the Axis selector key again to set the scale
absolute zero point selection mode.
• This setting is only valid when the Z
When the Z -axis or the Z -axis is displayed individually as the Z-axis display, the absolute zero
1 2
point of the displayed axis is valid. (If addition display is not selected by the axis addition setting,
that setting is not displayed.)
Operating Procedure
Select the Z-axis.
Pressing the key or
0
absolute zero point axis.
Note
If the absolute zero point is not selected correctly when addition display is used for the Z-axis,
absolute zero point detection processing will not be performed even though the absolute zero
point is passed.
or key.
0
Displacement of the second axis
Displacement of the third axis
Displacement of the second and third axes added
" when using the counter unit with 3-axis input for the X-axis,
". Set to " " when using the third axis. The third axis is not
-axis or Z -axis absolute zero point is to be used as the
1 2
-axis.)
2
-plus-Z addition display is used as the Z-axis display.
1 2
key changes the
Displayed Data
Display
REF
Flashes
REF
Flashes