Operation; Cautions On Operation; Initial Settings - Sony LH51 Bedienungsanleitung

5. Operation

Cautions on Operation

1) When a malfunction occurs, characters as shown in "8. Alarm Display" on page 66 are
2) If two or more operation keys are pressed simultaneously, a malfunction may be caused.
3) Make sure that the least significant digit of an entered value agrees with the selected

5-1. Initial Settings

Before staring the operation, make the following initial settings:
• Items marked with a dash (––) indicate unnecessary initial settings for the respective model.
• Skip unnecessary initial settings by pressing an Axis selector key, and proceed to the next
• By pressing the
• To save the initial settings, press the
displayed in place of numerals.When the alarm display appears, press the
relevant axis and repeat the operation.
resolution.
5-1-1. Setting the resolution and polarity
5-1-2. Setting the display resolution
5-1-3. Setting the linear compensation
5-1-4. Setting the distance from the absolute zero point of the scale
to the cutting datum point
5-1-5. Absolute zero point clear control
5-1-6. Setting of touch sensor radius (LH51 only)
5-1-7. Selecting addition display/single axis display (LH52 only)
5-1-8. Selection of absolute zero point of scale (LH52 only)
5-1-9. Setting inch/mm switching
These items are automatically canceled and cannot be selected. Initial settings required for the
specific model are indicated with a circle (\).
setting. After all the initial settings are completed, press the
displayed, and the unit enters measurement mode. This saves the initial settings.
key at any time during initial setting, the value that was displayed before
RESET
the power was turned off is displayed, and the unit is switched to the measurement mode.
is pressed, the unit enters measurement mode, and the settings are saved. The settings
RESET
are not saved unless the
RESET
Once the initial settings are saved, they remain stored even if the power is turned off. Therefore,
the initial settings are only made when installing the unit or modifying the setting values, and
they do not need to be made in normal operation.
Initial setting item
key after making the initial settings. When the
RESET
key is pressed.
key for the
RESET
Model
LH51 LH52
\ \
\ \
\ \
\ \
\ \
\ ––
–– \
–– \
\ \
key. The setting values are
RESET
11