Flat Keyboard - Sony LH51 Bedienungsanleitung

4-2. Flat Keyboard

• LH51 and LH52 keys
Reset and cancel keys
Name of part
Resets displayed value to zero.
RESET
Reset key
1. Cancels a value set on the axis.
2. Releases the hold value to
Cancel key
Designation of operation axis and presetting of
values
Name of part
Select an axis to give a command for
X Y Z
the selected axis.
Axis selector key
Sets desired values and a decimal
0 9
point.
Number keys
Sets a value of minus polarity.
Press this key before setting a
numeric value.
Polarity selector key
Displays a preset value.
P
If a new value is not input, the
previous preset data is displayed.
Preset key
Switches between ABS and INC
displays.
Display mode selector key
Function
display the current value.
Function
Establishment of datum point
Name of part
1. Halves the displayed value in the
C L
2. Touch sensor hold display is
1/2 key
Establishes a datum point.
S
Datum point setting key
• LH51 keys
Name of part
Used to select the Bolt hole circle/
S i m p l e R c u t t i n g m o d e o r t h e
Absolute zero point detection mode.
F
When this key is pressed, the mode
is switched in the order of the Bolt
Function key
hole circle/Simple R cutting mode,
Absolute zero point detection mode,
and Touch sensor mode.
1. Used to start the counting when
SET
L
( L for 1-axis display)
2. U s e d t o m a k e t h e v a r i o u s
Function setting key/
LOAD key
1. Used to hold the value displayed
START
2. Used to store the hold display
H
( H for 1-axis display)
Execute key/HOLD key
3. Used to start the processing in
Function
INC mode.
canceled, and the present position
from the center of the workpiece is
displayed. (LH51 only)
Function
the Touch sensor touches the
datum plane or passes the
absolute zero point of the scale.
settings in the Bolt hole circle/
Simple R cutting mode.
the moment the Touch sensor
touches the datum plane or
passes the absolute zero point of
the scale.
v a l u e i n t h e m e m o r y o r t o
release the hold display to
display the current value in the
Absolute zero point detection
mode.
the Bolt hole circle/Simple R
cutting mode.
9