Nolan N60-5 Sicherheit Und Gebrauchsanleitung Seite 15

6 CHEEK PAD ASSEMBLY
6.1 Insert the rear flap of the comfort padding of the left cheek pad into the cavity
between the rear seal and the inner polystyrene shell (Fig.7).
6.2 Insert the chin strap into the cavity in the cheek padding and press at the three
snap fasteners placed on the back to hook it in the relevant housing (Fig.6).
6.3 Repeat the same process with the right cheek padding.
Warning: the buttons are hooked on only when you hear the click. Make sure that the
strap is coming out well from the cheek padding.
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it
down as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet without having completely and correctly reassembled its
inner comfort padding and its cheek pads with expanded foam.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to dry
at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
EYEWEAR ADAPTIVE
1 CREATING SPACE FOR THE EYEWEAR
1.1 Remove the left cheek pad from the helmet (see instructions above).
1.2 Unhook the eyelet "A" on the rear frame of the corresponding cheek pad at the
upper press stud on the back (Fig.12).
1.3 Remove the upper flap "B" of the frame from the loop on the back of the frame
itself (Fig.12).
1.4 Gently remove the inner expanded foam padding from the fabric lining cover of the
cheek pad (Fig.13).
1.5 Detach the upper part of the pre-lined inner padding (Fig.13), then correctly repo-
sition the remaining part of the padding in the cheek pad.
It is recommended that you keep the removed padding for reuse in the
future.
1.6 Insert the upper flap "B" of the frame into the loop on the back of the cheek pad
and reattached the eyelet "A" at the top press stud on the back (Fig.12).
1.7 Remove the left cheek pad from the helmet (see instructions above).
1.8 Repeat the same process with the right cheek padding.
INSTRUCTIONS FOR USE
N60-5
15