Nolan N60-5 Sicherheit Und Gebrauchsanleitung Seite 14

N60-5
1.3 Remove the rear flap of the comfort padding on the left side from the cavity be-
tween the rear seal and the inner polystyrene shell; then completely remove the
cheek padding from the helmet (Fig.7).
1.4 Repeat the same process on the right side of the helmet.
2 DISASSEMBLY OF INNER EXPANDED FOAM CHEEK PADDING
To make it even easier to wash the parts of the inner comfort padding, the cheek pads
on the helmet come with internal padding in expanded foam that can be removed from
the fabric lining cover. To remove this padding, proceed as follows after removing the
cheek pads from the helmet (see instructions above).
2.1 Unhook the three eyelets "A" of the rear frame on the left cheek pad at the three
press studs (top, front and rear) on the back (Fig.8).
2.2 Remove the upper flap "B" and lower flap "C" of the frame from the respective
loops on the back of the frame itself (Fig.8).
2.3 Gently remove the inner expanded foam padding from the fabric lining cover of the
cheek pad (Fig.9).
2.4 Repeat the same process with the right cheek padding.
3 LINER DISASSEMBLY
3.1 Release the rear left flap of the liner from the rear edge of the shell by gently pulling
the comfort padding towards the inside (Fig.10). Then repeat the process also with
the rear right flap.
3.2 Grasp the front left area of the liner and pull it upwards to remove the relative flap
from the support fixed to the inner polystyrene shell (Fig.11).
Then repeat this process also for the centre and right forehead flaps.
3.3 Completely remove the liner from the helmet.
4 LINER ASSEMBLY
4.1 Correctly insert the liner into the helmet, lying it carefully on the bottom.
4.2 Insert the front left flap of the liner into the corresponding housing in the support
fixed to the polystyrene inner shell and push it downwards until it locks completely.
Then repeat this process also for the centre flap and the right flap (Fig.11).
4.3 Insert the right and left rear flaps of the liner in their respective housing on the
edge of the shell (Fig.10). Push the flaps until they are completely hooked to the
support.
5 ASSEMBLY OF INNER EXPANDED FOAM CHEEK PADDING
5.1 Gently insert the inner expanded foam padding into the left cheek pad fabric lining
cover (Fig.9). Carefully spread out the padding, checking that there are no wrinkles
in the cheek pad fabric cover
5.2 Remove the upper flap "B" and lower flap "C" of the frame in respective loops on
the back of the frame itself (Fig.8).
5.3 Unhook the three eyelets "A" of the rear frame on the left cheek pad at the three
press studs (top, front and rear) on the back (Fig.8).
5.4 Repeat the same process with the right cheek padding.
14
INSTRUCTIONS FOR USE