Nolan N60-5 Sicherheit Und Gebrauchsanleitung Seite 12

N60-5
VISOR
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until
it clicks (Fig.1).
1.3 Free the visor fastenings (B1 and B2) from their housing (Fig.2).
1.4 Follow the same steps on the other side of the helmet.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) in line
with the housings in the visor mechanism (Fig.2).
2.2 Insert fastening B1 into the provided housing and press the visor against the shell
in line with fastening B2. This will push the visor release button (A).
2.3 Slide the visor backwards until the visor release button (A) clicks.
2.4 Follow the same steps on the other side of the helmet.
2.5 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure that the mechanisms hold it in the different positions. If necessary,
repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
(Available as standard or accessory/spare part)
1 INNER VISOR PINLOCK
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.3).
1.3 Put the PINLOCK
The silicone-sealed profile of the PINLOCK
with the inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.4).
1.5 Widen the visor and fasten the other side of the PINLOCK
ond pin (Fig.5).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor on the helmet - as per instructions above.
12
INSTRUCTIONS FOR USE
ASSEMBLY
®
inner visor onto the visor.
®
inner visor on one of the two visor pins and hold
®
inner visor should be in contact
®
inner visor to the sec-
®
inner visor and check that the
®