SATA SATAminijet 1000 K Bedienungsanleitung Seite 467

Operating Instructions SATAminijet 1000 K/H RP/HVLP
• Check if locking screw [1-9] has been firmly tightened! Air micrometer
[1-8] could shoot out from the spray gun uncontrolled!
9.5. Replacing the Sealing (air side)
• Disconnect spray gun from the compressed air circuit!
Steps: [10-4], [10-5], [10-6], [10-7], [10-6], [10-5] and [10-4]
Replacing the self-adjusting seal [10-7] is required when air leaks from
under the trigger.
After disassembly, please check air piston rod [10-8] and clean it, if re-
quired. If damaged (e.g. if scratched or bent), replace it and grease with
SATA high performance spray gun grease (Art. No. 48173) and insert.
Please observe correct order of installation!
After installation, please adjust material flow according to chapter 7.2.
• Check if locking screw has been firmly tightened! Air micrometer could
shoot out from the spray gun uncontrolled!
9.6. Replacing the spindle of round/flat spray con-
trol
Steps: [11-1], [11-2], [11-3], [11-2], [11-1]
The spindle has to be replaced when air leaks from the spray control or
when the spray control does not work.
Danger!
Danger!
Danger!
US
467