Novoferm N-423 Montageanleitung Seite 45

3. Press the programming button (PROG button) (D).
The display shows "8".
Menu 8:
Door adjustments
1. Select menu item "8".
After about 2 seconds the display blinks and the set value time appears.
The factory setting is "4"
This setting should be maintained. A change in the soft run routes may be made only with the express
permission of the door manufacturer.
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) buttons.
Menu value
0
1
2
3
4
5
6
7
8
9
Remarks:
- These values correspond to the soft run courses measured on carriages.
3. Press the programming button (PROG button) (D).
The display shows "9".
Menu 9:
Adjustment other operating modes
1. Select menu item "9".
After approximately 2 seconds, the display flashes and shows the set value of the operating mode.
The factory setting is "0".
N-423
Start OPEN
0
15
0
15
25
15
15
35
55
Stop OPEN Start CLOSE
0
0
15
15
30
15
15
35
15
only soft run
Stop CLOSE
0
15
0 40
15 35
25 40
15 55
15 15
65 45
15 100
Installation
0
0
45