Novoferm N-423 Montageanleitung Seite 42

Installation
Menu 2:
Programming the 4-minute light
1. Briefly press the programming button (PROG button) (D) twice.
The display shows "2".
2. Press the button on the hand-held transmitter to control the light until the
digital point (A1) flashes 4 x.
3. As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
Note: Programming the ventilation position and partial opening:
see menu 9.
Note: Up to 30 codes can be learned.
(Example 15x start 15x light).
Delete all radio codes
1. Pull the main plug
2. Push and hold the oval PROG-Button (D).
3. Connect the mains plug to the mains socket and keep the PROG button
(D) pressed until the digital point flashes quickly.
Menu 3 + Menu 4:
Setting the end positions
1. Keep the programming button (PROG button) (D) pressed in for
approximately 3 seconds. The display shows "3".
2. Press the OPEN button (B) and check if the garage door moves to the
OPEN position.
3. If the garage door moves in the wrong direction, keep the programming
button (PROG button) (D) pressed in for approximately 5 seconds until a
chaser light appears.
4. Keep the OPEN button pressed until the garage door is at the desired
end position OPEN. If needed, press the CLOSE button (C) to adjust the
position.
5. Once the garage door is at the desired OPEN position, press the
programming button (PROG button) (D). The display shows "4".
6. Press the CLOSE button (C) as soon as the display flashes.
7. Keep the CLOSE button pressed until the garage door is at the desired
end position CLOSE. If needed, press the OPEN button (A) to adjust the
position.
8. Once the garage door is at the desired end position CLOSE, press the
programming button (PROG button) (D). The display shows "0".
9. Continue with the force learning cycle.
42
B
D
C
A1
B
D
C
B
D
C
N-423